Skip to content

Feedstock Hopper: Feedstock

Bulk density and particle size are properties of the shred, not of the polymer – they depend on the shredder, its screen, and how the material settles. So they travel with the machine and the material together, and are worth recording rather than looked up.

Material Polymaker PolyLite PLA, black
Form shredded in-house, sieved to 3 mm
Method gently settled in a beaker to the 700 mL line
Mass 342 g
Bulk density 0.489 kg/L

That is 40% denser than the 0.35 kg/L previously assumed from general practice, and it moves two numbers that matter:

  • Capacity up. The 202 x 202 two-segment hopper holds 4.24 kg, not 3.03.
  • Wall stress up. Pressure scales with density, so the bin wall goes from 4.49 MPa to 6.27 MPa – safety factor 6.7 down to 4.8. Still sound, but it is now the number to watch, and creep is what a safety factor does not cover. See loads.md.

Settling matters: gently settled is the right basis here, because a hopper’s contents settle under their own weight. Poured loose would read lower and under-predict both capacity and wall load.

The 60 and 70 degree wall angles remain design targets from general bulk-solids practice, not measurements. The critical mass-flow angle depends on the wall friction of the surface material slides on, and a printed wall is nothing like the steel those figures assume. Measuring it against a printed surface is tracked in #7.

Virgin pellet density is still the general-practice 0.62 kg/L. Worth measuring the same way if virgin ever becomes the main feedstock.

Bulk density and flow behaviour differ between polymers, between grades, and between shredder settings. Recording what was measured, on what, and how means a future comparison – PETG against PLA, a finer screen, a different shredder – has something to compare against rather than starting over.