Pipe Fitting Generator: Docs
The fittings were tested with water only. See Performance Testing for what the tests do and do not establish.
Threads
Section titled “Threads”The candidate threads are the external (-ext) threads in threadlib’s THREAD_TABLE.scad. pfDesigner.scad keeps those whose support diameter is from input_dia + gasket_thickness_lower / 2 to input_dia + gasket_thickness_upper / 2.
Parameters
Section titled “Parameters”The parameters at the top of pfDesigner.scad, with their defaults. Lengths are in mm.
| Parameter | Default | What it does |
|---|---|---|
input_dia |
12 | Outside diameter of the pipe being coupled. |
gasket_thickness_upper |
15 | With gasket_thickness_lower, sets the support diameter range used to pick candidate threads. |
gasket_thickness_lower |
13 | See gasket_thickness_upper. |
gasket_extra_length |
3 | Length added to the gasket beyond the thread so the nut compresses it. Must be more than the thread pitch. |
tol_pipe |
0.2 | Radial clearance between the pipe and the fitting and nut bores. |
tol_gasket |
0.1 | Radial clearance between the pipe and the gasket bore. Must be less than tol_pipe. |
turns |
5 | Thread turns on the fitting and nut. Also sets the gasket length with gasket_extra_length. |
wall_thickness |
1.2 | Wall thickness of the fitting. The gasket fills the fitting’s bore, so this also sets the gasket’s outside diameter. |
middle_length |
20 | Length of the fitting’s centre tube; each half of the fitting gets middle_length / 2. |
transition_length |
15 | Sets the section between the thread and the centre tube; the code uses transition_length / 2, which is also the length of the gasket’s taper. |
cap_thickness |
1 | Thickness of the nut’s end cap. |
nut_wall_thickness |
2.4 | Wall thickness of the nut. |
flat_gasket_thickness |
2 | Thickness of the flat disc gasket used with the closed nut. |
entry_chamfer |
true | Chamfers the thread entry on the fitting and nut. |
style |
"Hexagon" |
Outer shape of the fitting body and nut: "Hexagon", "Cone" or "Circular". |
selectedThread |
5 | Index of the candidate thread to use, from 0 to one less than the number of candidates. |
export |
true | true renders only selectedPart. false shows every candidate thread with its gasket, and the selected fitting, nut and gasket, plus closed_nut or flat_gasket when one of those is selected. |
selectedPart |
"all" |
fitting, nut, gasket, closed_nut, flat_gasket, or all (fitting, nut and gasket). |
showInputPipe |
false | Shows the pipe for reference, when the selected part includes the fitting. |
