Skip to content

Wiring

These are the FAST group's own lab signs. They are written for one lab, its equipment, its layout and its local procedures, and are published so others can see and adapt them. They are not general safety guidance and they are not a substitute for training.

If you work somewhere else, follow your own workplace procedures and the requirements of your institution and jurisdiction.

reviewawaiting PI, post-doc, equipment owner or subject-matter reviewv0.1 · review owner: Cameron B. / Dr. Pearce / qualified electrical reviewer · updated 2026-11-14
  • Do not wire mains, high-power, heaters, motors, batteries, or permanent equipment unless trained and authorized.
  • Do not modify building wiring, outlets, breakers, power bars, extension cords, or certified equipment.
  • Use certified or appropriately rated components for the voltage, current, temperature, environment, and enclosure.
  • If a design depends on current rating, fuse sizing, wire gauge, grounding, insulation, or code, get review first.
  • Treat mains, large batteries, heaters, motors, high-current supplies, wet locations, unattended operation, or building-service connections as review-required.
  • Custom wiring that touches building mains must be reviewed and approved by a qualified electrical reviewer before power-up.
  • If you are unsure, stop and ask before energizing anything.
  • Start with a simple enclosure that is larger than you think you need.
  • Leave room for wiring, labels, strain relief, service loops, airflow, and future inspection.
  • Use standoffs, spacers, DIN rail, mounting plates, or other secure supports.
  • Keep wiring away from sharp edges, moving parts, hot surfaces, fans, belts, and pinch points.
  • Separate low-voltage control wiring from higher-power wiring when appropriate.
  • Label connectors, switches, power inputs, outputs, fuses, and unusual hazards.
  • Use an approved cord, switched outlet or disconnect, in-line fuse or circuit breaker, proper grounding, appropriate wire gauge, and a rated enclosure, with proper connectors, terminals, ferrules, crimps, insulation, strain relief, cable management, and clear labels for purpose and voltage.
  • Do not leave exposed conductors.
  • Do not rely on tape, hot glue, loose knots, or friction as permanent insulation or strain relief.
  • Do not daisy-chain power bars or extension cords, or use extension cords as permanent wiring.
  • Keep access to outlets, disconnects, panels, breakers, and emergency shutoffs clear.
  • Use GFCI or other protection where the procedure requires it, especially near wet or conductive areas.

For DC loads: $P = IV$ $\quad | \quad$ For resistive loads: $V = IR$ $\quad | \quad$ For a first-pass voltage-drop check: $\Delta V = IR$

Check voltage, current, power, connector rating, wire rating, fuse/protection, startup current, duty cycle, enclosure heat, and fault conditions together. Do not size wiring from one number alone.

  • Inspect for exposed conductors, wrong polarity, loose terminals, damaged insulation, and missing strain relief.
  • Check that fuses, breakers, connectors, wires, and supplies are rated for the expected load.
  • Review-required wiring, including mains, high power, heaters, motors and batteries, needs qualified review and first-power-up approval: ask Cameron B. or Dr. Pearce for the reviewer.
  • Stay with the equipment during first power-up and be ready to disconnect power.

Source: lab-signs/wiring.md · all signs and records