FFF Printers
These are the FAST group's own lab signs. They are written for one lab, its equipment, its layout and its local procedures, and are published so others can see and adapt them. They are not general safety guidance and they are not a substitute for training.
If you work somewhere else, follow your own workplace procedures and the requirements of your institution and jurisdiction.
reviewawaiting PI, post-doc, equipment owner or subject-matter review
After Every Print
Section titled “After Every Print”- Remove your part, supports, purges, brims, skirts, rafts, and loose filament from the printer.
- Leave the bed, tool area, and printer surroundings ready for the next user.
- Put tools back where they belong.
- Sort clean print waste according to Waste Disposal.
- Watch for hot nozzles, hot beds, sharp scrapers, brittle prints, and sharp filament ends.
Failed Prints
Section titled “Failed Prints”- Stop failed prints promptly when you notice them.
- Remove failed material when it is safe to do so.
- Do not restart the same failing job repeatedly without checking the cause.
- Report printer problems instead of leaving them for the next user.
Material Waste
Section titled “Material Waste”| Waste | Action |
|---|---|
| Clean PLA, PETG, or ABS scrap | Use the black material-labeled cans near the TEB6 shredders/extruders. |
| Mixed polymer, dirty plastic, composites, nylon, TPU/TPE, or unknown material | Do not use polymer recycling; follow Waste Disposal or ask. |
| Sharp scraps or brittle failed prints | Handle carefully and clean the area before leaving. |
Ask First
Section titled “Ask First”- Ask before changing hardware, firmware, nozzle size, bed surface, slicer defaults, or material settings for shared printers.
- PLA, PETG, and TPU/TPE are approved on any of the five shared printers.
- Run ABS/ASA only in one of the three enclosed Prusa MK3 printers, with the door closed and the HEPA filter fan on. Two of the five are not enclosed and must not be used for ABS/ASA.
- Ask before using nylon, composites, carbon fiber, glow, soluble supports, high-temperature, or other unusual materials.
- If you are unsure whether a printer is safe to use, leave it stopped and ask the PI or a post-doc.
- If you find a printer issue, fix it immediately if you can do so safely and confidently. Otherwise, stop the printer if needed, message the group so people know not to use it, and contact the PI or a post-doc.
