Waste Disposal
These are the FAST group's own lab signs. They are written for one lab, its equipment, its layout and its local procedures, and are published so others can see and adapt them. They are not general safety guidance and they are not a substitute for training.
If you work somewhere else, follow your own workplace procedures and the requirements of your institution and jurisdiction.
reviewawaiting PI, post-doc, equipment owner or subject-matter review
Before You Throw It Out
Section titled “Before You Throw It Out”- Reduce waste when you can: plan jobs, prints, cuts, and purchases carefully.
- Reuse clean, simple materials when they are likely to be useful again.
- Recycle only clean materials that belong in an approved recycling stream.
- Discard only when reuse and recycling are not appropriate.
- If it is contaminated, hazardous, unlabeled, or unknown, stop and ask.
Common Waste Streams
Section titled “Common Waste Streams”| Item | Preferred action | Notes |
|---|---|---|
| Clean plates, blanks, blocks, containers, or simple offcuts | Reuse | Keep only if someone can realistically use it again. |
| Clean known PLA, PETG, or ABS print waste | FAST polymer recycling | Use the black material-labeled cans near the TEB6 shredders/extruders. Mixed color is OK within one polymer; mixed polymer is not accepted. |
| Small skirts, FFF purge lines, tiny scraps, dirty prints, composite prints, TPU/TPE, nylon, or mixed-polymer waste | Garbage or ask | Do not put these in polymer recycling. |
| Paper or cardboard | Paper/cardboard recycling | Small bins are by the TEB6/TEB7 doors; large blue bins are in hallways or the loading dock area. |
| Clean accepted containers | Container recycling | Confirm the campus stream before using it. |
| Food-contaminated or dirty non-hazardous waste | Garbage | Do not contaminate recycling streams. |
| Chemical, resin, oil, grease, solvent, acid, base, biological, or unknown waste | Ask / approved waste procedure | Do not pour down the sink or place in regular trash/recycling. |
Do Not Guess
Section titled “Do Not Guess”- Do not neutralize, dilute, evaporate, rinse, or pour out chemical waste unless an approved procedure explicitly says to do so.
- Discharging hazardous waste to the sewer is prohibited by the Canadian Environmental Protection Act and the City of London Waste Discharge Bylaw.
- Do not mix waste streams to make discarding easier.
- Do not put contaminated material in paper, container, or polymer recycling.
- Western hazardous waste guidance says unknowns must be identified or characterized before acceptance.
- The person who generated the waste must segregate and label it correctly before asking the PI/post-doc to submit the Western hazardous-waste pickup request.
- Pickup is weekly on Thursdays through RPR Environmental and needs an inventory form. Waste is handed over in person and never left unattended.
- Hazardous waste awaiting pickup must be in a proper, labeled, compatible container below the sink, in the flammables cabinet, or in a fume hood cabinet as appropriate for the waste.
- When in doubt, ask the PI, a post-doc, or the responsible equipment owner.
Special Streams
Section titled “Special Streams”| Item | Action |
|---|---|
| Unknown chemical or unlabeled liquid/solid | Do not discard. Identify or characterize through the approved Western hazardous-waste process. |
| Batteries | Use the battery bin on the south wall counter of TEB7. All common chemistries are accepted; tape the terminals. |
| Damaged, swollen, leaking, hot, or unknown batteries | Do not put in the battery bin. Stop and ask the PI or a post-doc. |
| Electronics, circuit boards, cables, or e-waste | Use the e-waste bin on the south wall counter of TEB7. Classed as hazardous waste; never landfill garbage. |
| Broken glass or sharps | Glass and sharps go in separate containers. See Broken Glass and Sharps. |
| Aerosols, spray paints, lubricants, oils, greases, or solvents | Use the approved hazardous-waste or special-waste process. Store only in compatible, labeled containers. Keep halogenated and non-halogenated solvents separate and list full chemical names. |
| Empty chemical/resin bottles or contaminated containers | Do not recycle until the approved procedure says they are empty/clean enough. |
Related
Section titled “Related”- See Batteries and E-Waste.
- See Broken Glass and Sharps.
Sources / Procedure Links
Section titled “Sources / Procedure Links”- Western hazardous waste: https://www.uwo.ca/hr/safety/topics/hazardous_waste.html
- Western Laboratory Health and Safety Manual: https://www.uwo.ca/hr/form_doc/health_safety/doc/manuals/lab_safety_manual.pdf
- Western sorting guidance: https://sustainability.uwo.ca/campus/waste-reduction/what-goes-where.html
- Western recycling and waste services: https://uwo.ca/fm/what/maintenance/recycling.html
- Western knife/sharps safety: https://www.uwo.ca/hr/safety/topics/knife_safety.html
- Western Hazardous Materials and Waste Management Handbook: https://www.uwo.ca/hr/form_doc/health_safety/doc/manuals/hazardous_handbook.pdf
