Resin Printers
These are the FAST group's own lab signs. They are written for one lab, its equipment, its layout and its local procedures, and are published so others can see and adapt them. They are not general safety guidance and they are not a substitute for training.
If you work somewhere else, follow your own workplace procedures and the requirements of your institution and jurisdiction.
reviewawaiting PI, post-doc, equipment owner or subject-matter review
Before You Print
Section titled “Before You Print”- Use resin printers only after training on the printer, wash/cure workflow, PPE, and waste process.
- Wear eye protection in TEB6. Use nitrile gloves, protective clothing, ventilation, and any other PPE required by the resin, solvent, or posted procedure before handling resin, resin-contaminated parts, build plates, vats, tools, wipes, or wash liquid.
- Wear long pants and closed-toe shoes.
- Keep resin work inside the resin printer area.
- Check that waste containers, wipes, tools, and cleanup supplies are available before starting.
- Keep resin and wash solvents away from ignition sources unless the approved setup says otherwise.
- The resin printer setup currently covers the Prusa SL1S and CW1S.
While Working
Section titled “While Working”- Avoid skin and eye contact with uncured resin.
- Keep bottles, vats, and wash containers closed when not actively in use.
- Keep contaminated gloves, wipes, tools, and parts away from clean surfaces.
- Clean minor drips only if you have been trained on the approved resin cleanup process.
- Stop and ask if there is a spill, leak, damaged vat, unusual odor, or printer fault.
Waste And Cleanup
Section titled “Waste And Cleanup”| Item | Action |
|---|---|
| Uncured resin or resin-contaminated liquid | Collect in the designated hazardous-waste container. Do not pour down the sink. |
| IPA or other resin wash solvent | Collect in the designated hazardous-waste container. Keep away from ignition sources. |
| Resin-contaminated wipes, gloves, supports, filters, bottles, or failed prints | Collect in the designated resin waste bag/container unless fully cured and the approved procedure says otherwise. |
| Finished parts | Wash and cure according to the approved workflow before normal handling. Fully cured, uncontaminated resin parts may go to garbage if local procedure allows; do not recycle cured resin. |
| Unknown or mixed waste | Stop and ask Alessia R., the PI, a post-doc, or the responsible owner. |
Exposure Or Spill
Section titled “Exposure Or Spill”- For skin or eye exposure, follow emergency procedures immediately and report the incident.
- Minor cleanup means a small drip or smear that a trained user can clean immediately without spreading contamination or using unusual PPE.
- For larger spills, spills outside the resin area, strong odor, skin/eye exposure, solvent spill, broken vat, leaking bottle, or anything you are not confident cleaning, stop, keep others away, and get help.
When Done
Section titled “When Done”- Return resin bottles, tools, and PPE supplies to their proper places.
- Leave the printer, wash/cure station, and surrounding bench clean.
- Label or remove your parts so the next user knows what is safe to handle.
- Report low supplies, damage, spills, or printer problems.
Related
Section titled “Related”- See Waste Disposal before discarding resin or contaminated material.
Sources / Procedure Links
Section titled “Sources / Procedure Links”- Western hazardous waste: https://www.uwo.ca/hr/safety/topics/hazardous_waste.html
- Formlabs resin disposal support: https://support.formlabs.com/s/article/Disposing-of-resin
- Formlabs IPA support: https://support.formlabs.com/s/article/Isopropyl-Alcohol-IPA
