Manual Tools
These are the FAST group's own lab signs. They are written for one lab, its equipment, its layout and its local procedures, and are published so others can see and adapt them. They are not general safety guidance and they are not a substitute for training.
If you work somewhere else, follow your own workplace procedures and the requirements of your institution and jurisdiction.
reviewawaiting PI, post-doc, equipment owner or subject-matter review
Use The Right Tool
Section titled “Use The Right Tool”- Match the tool to the material, size, and force required.
- If a tool is flexing, slipping, denting, cracking, or taking excessive force, stop and choose a different tool.
- Do not use precision flush cutters on hard wire, steel rod, screws, nails, thick plastic, or anything beyond their rating.
- Do not use screwdrivers as pry bars, pliers as hammers, cutters as wire strippers, or knives as general-purpose scrapers.
- If you are not sure which tool is right, ask the PI or a post-doc.
Before And During Use
Section titled “Before And During Use”- Inspect blades, jaws, handles, insulation, and moving parts before use.
- Cut away from yourself and others.
- Keep fingers out of pinch, cut, and snap-back zones.
- Use eye protection when cutting wire, clipping leads, trimming brittle material, or working with springy parts.
- Clamp or support the work when practical.
When Done
Section titled “When Done”- Put tools back on the counter holders, cabinets, or south-wall hex pegboard holders in TEB7.
- Clean debris, wire ends, and offcuts from the bench.
- Report damaged, dull, cracked, loose, or unsafe tools.
Damaged Tools
Section titled “Damaged Tools”- Stop using damaged tools immediately.
- Leave a clear note on the tool if it could injure the next user.
- Tell the PI or a post-doc so the tool can be repaired, replaced, or removed.
Related
Section titled “Related”- See Power Tools for hand-held powered tools.
- See Stationary Tools for fixed powered tools in TEB6.
Sources / Procedure Links
Section titled “Sources / Procedure Links”- Western knife and sharp object safety: https://www.uwo.ca/hr/safety/topics/knife_safety.html
